Crystal Clear Epoxy Resin For General Purpose Bar Table Top Coating Wood – 2 Gallon Kit (Combined)
UV Stable Crystal Clear Resin is a high performance two component Clear epoxy system designed for Table Tops, Bars, Wood finishes, See-Through
Encapsulations, Art work, and other applications requiring a clear, strong, plastic coating specifically designed to resist Yellowing caused by the sun and other Ultra Violet light sources. The material has an easy to use 1 to 1 by volume mix ratio, wets out substrates well, maintains its integrity over sharp corners, it has excellent air release qualities, and a relatively fast set time for an epoxy coating which may be accelerated by mild heat to 160F. While this material will do much better then competitors products for non yellowing we still do not recommend it for permanent outdoor applications.
Self Leveling, High Gloss
U.V. Resistant Formula
Excellent Air Release
Excellent Color StabilityImproved Impact Strength
Improved Surface Appearance
Early Development of Physical and Performance Properties
Produces a Tough, High Gloss, Water Resistant Coating
Eliminates Craters, Crawling and Fish Eyes
Base Resin A-Side Curing Agent B-Side
Appearance: Clear Syrup Clear Syrup
Viscosity, Spindle #4 @ 6 rpm: 12,000 (+/- 2,000) 1,150 (+/- 300)
Weight per Gallon: 9.6 Lbs. 8.0 Lbs.
Mix Ratio: 1 to 1 by Volume
Gel-Time (100 gr. mass): 25 minutes (+/- 5 min.)
1/4” Casting Tack Free Time: 2.5 hours (+/- 30 min.)
Thin film Set Time 4 to 8 Hours depending on thickness and ambient temperature
Full Cure 24 to 48 hours for optimum properties
Hardness 70—75 Shore D (full cure)
Elongation > 15%
Mix material slowly to avoid excess air entrapment, after applying wait several minutes then eliminate bubbles
with a heat gun or alcohol mist. Substrates must be clean and area should be dust free.
This material is for professional use only, using adequate ventilation and protection from eye and
skin exposure. Any information supplied with this material is given in good faith but should be
verified by the end user, as is the suitability of the material for their application. The warranty of this
material shall be limited to the replacement of defective material.